The mini self loading concrete mixer for sale has built-in highly intelligent equipment, which can realize automatic feeding and automatic water injection. Two workers can control the daily output to reach 2.6-6.5 cubic meters per cubic. The key components of mini self loading concrete mixer are imported from Germany, and they can be put on the road after listing. It is a new generation of construction artifact.

The mini self loading concrete mixer for sale are consist of 3 major system:
1, In and out system
The feeding and discharging system of the self loading concrete mixer is composed of a feeding hopper, a discharging hopper, a main discharge chute, an auxiliary discharge chute, a bracket, a locking frame, etc. It is an important part of the self-loading mixer, which directly affects the feeding and discharging speed and quality. The inlet and outlet hoppers are connected with the backstage support frame of the subframe through the bracket. There are lining plates in the discharge hopper and the main discharge trough. The lining plate is made of high-strength fine-grained alloy steel, and its wear resistance is 1.59 times that of Q345A (original 16Mn), which greatly improves the wear resistance. The main discharge chute can discharge the concrete in the required direction, and the auxiliary discharge chute can extend the length of the main discharge chute.

When the auxiliary discharge chute is extended, pull down the lock handle on the auxiliary discharge chute and lock it. The locking frame locks the main discharge chute when the discharge chute is not working. When the unloading chute is not working, push it inwards, it will automatically lock, lift the lock handle, and then the unloading chute can be pulled out.

The discharge chute control rod plays the role of slewing support for the discharge chute and adjusts the up and down displacement of the notch of the discharge chute. It is driven by a screw screw, with accurate positioning, reliable connection, and light and labor-saving movement. The locking lever will lock the discharge chute turned to either position. Lift the handle to release the lock.

2, Operating system
The operating system of the self loading concrete mixer is composed of a controller, a linkage shaft, a flexible shaft and a connecting rod mechanism, which mainly controls the rotation speed and rotation direction of the mixing drum. A set of controllers are arranged on both sides of the rear of the self loading mixer. The left and right controllers can be linked together. There is only one joystick on the controller. The angle of the control handle is used to adjust the flow rate of the oil pump, so as to control the direction and speed of the rotation of the cylinder, which can be controlled by moving the handle left and right; the handle is also connected to the throttle of the engine through a flexible shaft, which can be adjusted when the speed needs to be increased. Move up and down to manipulate the handle, and control the joystick to increase the rotation speed of the cylinder.

3, Electrical system
The electrical system of the mini self loading concrete mixer for sale consists of three parts: the cooling fan control part and the rear position light part. Cooling fan control part: The start and stop of the cooling fan is automatically controlled by the temperature switch. When the temperature is higher than 65°C, the fan starts, and when the temperature is lower than 60°C, the fan stops. The temperature switch is located on the cooler, and the relay and fuse are located in the power relay box next to the battery. Rear indicator light part: The rear indicator light is used to indicate the size of the rear of the car at night, and it is turned on and off at the same time as the rear license plate light.