How to disassembly hanging reducer of ready mixed concrete batching plant?

1, make the gear oil get our of machine

2. Discharge backstop’s cover and core plate, remove the inside ball, the top pin and spring, and then pulled core wheel, last to gently knock backstop outer ring out.

3. Remove all the screws and cover of reducer, beat hollow shaft with copper rod so that the box will be apart, and we can finally take out the gears.

4. Cleaning and checking the situation of gear and bearing, then repair or change it immediately.

5. When installed according to the reverse order of assembly of the above, adjusted the distance of gears according to the requirements of each bearing; backstop should pay attention to the direction of rotation according to gear head assembly.

6. To check whether the assembled operation is flexible and no string axis phenomenon, then add 220 medium load extreme pressure gear oil test.

7. The joints of the housing clean, evenly coated with sealant, close the lid, and put on the lid and seal bearing stuffy.